[prev in list] [next in list] [prev in thread] [next in thread]
List: cmake
Subject: Re: [CMake] =?utf-8?q?add=5Ftest=28=29_and_DEBUG=5FPOSTFIX?=
From: Martin Baute <solar () rootdirectory ! de>
Date: 2013-03-25 13:15:53
Message-ID: 36104512d15bc7172ca30f030bab51b3 () mail ! lcube ! de
[Download RAW message or body]
I did not get any feedback on this, so please excuse me asking again:
Is it by design that adding a DEBUG_POSTFIX to executables makes CMake
miss those very same executables when running "make test"?
It is a bit awkward having to chose between either:
A) having no postfix with executables, i.e. debug executables
overwriting
release executables on installation
or
B) not having "make test" work properly when building anything else but
the default / release build type.
Regards,
--
Martin Baute
solar@rootdirectory.de
Am 20.03.2013 12:51, schrieb Martin Baute:
> In my CMakeLists.txt, I defined tests to be run when I call "make
> test":
>
> add_executable( test_tu test/test_tu.cpp )
> set( ALL_TARGETS ${ALL_TARGETS} test_tu )
> add_test( test_tu test_tu )
>
> I also configured to have a postfix "-debug" when building in that
> config,
> so I could install release and debug versions side-by-side:
>
> set_property( TARGET ${ALL_TARGETS} PROPERTY DEBUG_POSTFIX
> "-debug" )
>
> However, when I build with CMAKE_BUILD_TYPE=Debug and call "make
> test",
> the Makefile will try to call "test_tu" - not "test_tu-debug".
> Apparently,
> the DEBUG_POSTFIX property is not considered by add_test().
>
> Is this by design, a bug, or a faulty config on my part?
>
> Regards,
--
Powered by www.kitware.com
Visit other Kitware open-source projects at http://www.kitware.com/opensource/opensource.html
Please keep messages on-topic and check the CMake FAQ at: http://www.cmake.org/Wiki/CMake_FAQ
Follow this link to subscribe/unsubscribe:
http://www.cmake.org/mailman/listinfo/cmake
[prev in list] [next in list] [prev in thread] [next in thread]
Configure |
About |
News |
Add a list |
Sponsored by KoreLogic