[prev in list] [next in list] [prev in thread] [next in thread]
List: cisco-nsp
Subject: Re: [c-nsp] MVPN Rosen interoperation configuration Cisco and
From: Mark Tinka <mtinka () globaltransit ! net>
Date: 2011-07-28 18:19:31
Message-ID: 201107290219.35049.mtinka () globaltransit ! net
[Download RAW message or body]
[Attachment #2 (multipart/signed)]
On Tuesday, July 26, 2011 07:51:10 AM David water wrote:
> Can someone please share the working Rosen MVPN
> configuration of Cisco and Juniper? Do I have to use
> vrf-table-label or VT interface on Juniper router to
> make it working?
Haven't worked with Rosen on this end, but NG-MVPN instead.
'vrf-table-label' and 'vt-' interfaces works fine across all
Juniper routers, but where a P router is a Cisco, only 'vt-'
interfaces work "correctly/better" than 'vrf-table-label',
particularly when a Juniper router is a bud node (both a
Receiver PE router as well as a mid-point/branch router).
I believe you just require Tunnel PIC's on the Juniper's if
you want to go the 'vt-' interfaces route.
Again, this is feedback on NG-MVPN. Haven't inter-op'ed
Cisco and Juniper for Rosen MVPN's.
Cheers,
Mark.
["signature.asc" (application/pgp-signature)]
_______________________________________________
cisco-nsp mailing list cisco-nsp@puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
[prev in list] [next in list] [prev in thread] [next in thread]
Configure |
About |
News |
Add a list |
Sponsored by KoreLogic