[prev in list] [next in list] [prev in thread] [next in thread]
List: caldera-netware
Subject: RE: Trouble with RedHat 5.1 and my SCSI Controller
From: Lawrence Mulder <lrm () dmv ! com>
Date: 1998-08-23 16:13:49
[Download RAW message or body]
one thing I forgot... don't forget to run lilo after updating the lilo.conf...
Good luck...
-Lawrence Mulder
mailto:lrm@dmv.com
> -----Original Message-----
> From: Lawrence Mulder [mailto:lrm@dmv.com]
> Sent: Sunday, August 23, 1998 11:46 AM
> To: 'caldera-netware@rim.caldera.com'
> Subject: RE: Trouble with RedHat 5.1 and my SCSI Controller
>
>
> Jason,
>
> The best way that I have found to do this is to use
> mkinitrd to create an
> initial ramdisk which is used to load scsi modules and such
> at boot time.
> once you do this you add a line to you lilo.conf under the
> section for the
> kernel which you are booting for your initrd. That should
> take care of
> your problem, as I had the exact same problem.
>
> Here is the mkinitrd command I used, and the kernel section from my
> lilo.conf...
>
> bash# mkinitrd --needs-scsi-modules /boot/initrd-aic7xxx 2.0.35
>
> lilo.conf:
>
> image=/boot/vmlinuz-2.0.35-modular
> label=streams-mod
> initrd=/boot/initrd-aic7xxx
> root=/dev/sda1
> read-only
>
> hope this helps...
>
> -Lawrence Mulder
> mailto:lrm@dmv.com
>
> > -----Original Message-----
> > From: Jason_Hollis@Dell.com [mailto:Jason_Hollis@Dell.com]
> > Sent: Friday, August 21, 1998 3:28 PM
> > To: Caldera-NetWare@rim.caldera.com
> > Subject: Trouble with RedHat 5.1 and my SCSI Controller
> >
> >
> > I've installed the Caldera Kernel and when I
> > try and boot it
> > I get a kernel panic. How do I make sure that the mod for
> > the 2940 is being
> > loaded?
> >
> > Jason Forrest Hollis
> > DellPlus Engineering
> > phone: 512.728.9214
> > pager(via email):
> > jason_hollis@pager.dellplus.dell.com
> > pager(voice): 800.269.8572
>
>
[prev in list] [next in list] [prev in thread] [next in thread]
Configure |
About |
News |
Add a list |
Sponsored by KoreLogic