[prev in list] [next in list] [prev in thread] [next in thread]
List: beowulf
Subject: Scyld, RMI, and ProActive
From: Simon Frost <sdfrost () ucsd ! edu>
Date: 2002-08-29 23:42:07
[Download RAW message or body]
Dear Beowulf list,
I'm sure that this is a dumb question, but I am a relative newbie...
I'm trying to get RMI working on my Scyld system. I'm using the ProActive
libraries (http://www-sop.inria.fr/sloop/javall/), which make the whole RMI
thing much easier. The problem is, when I try to create an RMI node on a
slave in the RMI registry, it only puts a node on the master, not on the
slave i.e.
./startNode.sh rmi://.1/1
puts a JVM on the master node (-1), rather than on node 1.
Alternatively, I can bpsh to the node in question:
bpsh .1 (fullpath)/startNode.sh rmi://.1/1
This initially mounts a node, but then I get an ArrayIndexOutOfBounds
exception.
Any ideas?
Thanks!
Simon
Simon D.W. Frost, M.A., D.Phil.
Department of Pathology
University of California, San Diego
Antiviral Research Center
(Formerly: UCSD Treatment Center)
150 W. Washington St., Suite 100
San Diego, CA 92103
USA
Tel: +1 619 543 8080 x275
Fax: +1 619 298 0177
Email: sdfrost@ucsd.edu
Work W3: http://www.avrctrials.org
Personal W3: http://www.simonfrost.com
_______________________________________________
Beowulf mailing list, Beowulf@beowulf.org
To change your subscription (digest mode or unsubscribe) visit \
http://www.beowulf.org/mailman/listinfo/beowulf
[prev in list] [next in list] [prev in thread] [next in thread]
Configure |
About |
News |
Add a list |
Sponsored by KoreLogic