[prev in list] [next in list] [prev in thread] [next in thread]
List: ataraid-list
Subject: Re: unable to re-read the partition table
From: Murty Rompalli <murty () solar ! murty ! net>
Date: 2002-06-13 19:07:50
[Download RAW message or body]
So is ataraid compiled as module or built into your BOOT kernel? Also, see
if any 'Unresolved symbols' using nm
I think boot time loading of linux ata raid directly has a lot of problems
7.3 and onwards. I wish I can see ATARAID as a feature under module list
just like I can see for megaraid or scsi if I boot with "linux noprobe"
Good luck
Murty
On 12 Jun 2002, Samuel Flory wrote:
> I'm running into a wierd issue using the Promise Fasttrak driver in RH
> 7.3. When I recompile the 2.4.18-3BOOT kernel to support the fasttrak
> chipset.* I get the following error from the installer. "The kernel was
> unable to re-read the partition table on hde".
>
> At 1st I thought this was entirely a driver issue, but if I drop to a
> shell durning the install and run fdisk, sfdisk, and parted. I can
> reread the partition no issues. If I select the option of using fdisk
> from the installer. The partition table is unable to be reread.
>
> As far as I can tell once I enter any of the partitioning screens I
> can't reread the partition table. Anyone have any ideas what the redhat
> installer is doing to cause the issue?
>
>
> *I used the options from kernel-2.4.18-i386-BOOT.config, and changed the
> following options to y:
> CONFIG_PDC202XX_BURST=y
> CONFIG_PDC202XX_FORCE=y
>
>
>
>
>
>
> _______________________________________________
> Ataraid-list mailing list
> Ataraid-list@redhat.com
> https://listman.redhat.com/mailman/listinfo/ataraid-list
>
_______________________________________________
Ataraid-list mailing list
Ataraid-list@redhat.com
https://listman.redhat.com/mailman/listinfo/ataraid-list
[prev in list] [next in list] [prev in thread] [next in thread]
Configure |
About |
News |
Add a list |
Sponsored by KoreLogic