[prev in list] [next in list] [prev in thread] [next in thread]
List: apache-httpd-dev
Subject: Re: Building the trunk
From: Jeff Trawick <trawick () gmail ! com>
Date: 2012-09-23 14:13:05
Message-ID: CAKUrXK4oBJgEXXmWRFU3SdRyiPqCadu6GyiM6zjYgt7eZjT1Tg () mail ! gmail ! com
[Download RAW message or body]
On Sat, Sep 22, 2012 at 3:40 PM, Benson Margulies <bimargulies@gmail.com> wrote:
> On Sat, Sep 22, 2012 at 2:51 PM, Graham Leggett <minfrin@sharp.fm> wrote:
> > On 22 Sep 2012, at 19:20, Benson Margulies <bimargulies@gmail.com> wrote:
> >
> > > I checked out http://svn.apache.org/repos/asf/apr/apr/trunk into
> > > srclib/apr, and then I ran buildconf, and then I tried to run
> > > configure.
> >
> > I am not sure the apr-inside-srclib works any more.
> >
> > In theory, build apr-trunk and make install it to a directory with --prefix, then \
> > point httpd at at by saying ./buildconf --with-apr=/path/to/apr-trunk
> > Apr-uti-trunk was combined with apr-trunk a while back.
> >
> > Regards,
> > Graham
> > --
> >
>
> Just to tie this off: the fun here began with a message from buildconf:
>
> You don't have a copy of the apr source in srclib/apr.
> Please get the source using the following instructions,
> or specify the location of the source with
> --with-apr=[path to apr] :
>
> svn co http://svn.apache.org/repos/asf/apr/apr/trunk srclib/apr
>
> So, if srclib is no longer a good idea, I suppose that buildconf needs
> a slight improvement. Anyway, mission accomplished.
Hopefully r1389060 gets rid of the bad hints and provides
basically-correct instructions regarding APR/APR-util in INSTALL which
others can massage as appropriate.
--
Born in Roswell... married an alien...
http://emptyhammock.com/
[prev in list] [next in list] [prev in thread] [next in thread]
Configure |
About |
News |
Add a list |
Sponsored by KoreLogic