[prev in list] [next in list] [prev in thread] [next in thread]
List: acpi4linux
Subject: [ACPI] Why don't use C2/C3 with high latency?
From: Ruediger Otte <tierra.y.libertad () gmx ! net>
Date: 2003-03-28 18:22:45
[Download RAW message or body]
Hi,
on my system (Gigabyte GA-7VTXH, VIA KT266A Chipset, Athlon XP 1600+)
the C2 processor powerstate have not been enabled until I set the
ACPI_PROCESSOR_MAX_C2_LATENCY to a value above 100. The system runs
quite normal after this change and consumes much less power than before.
Also the processor temperature goes down from 48°C to under 35°C when
idle.
So why is the MAX_C2_LATENCY set to this value? Is it possible to
optimize the use of this high latency C2 to only use it when the system
is _really_ idle?
--
Rüdiger
-------------------------------------------------------
This SF.net email is sponsored by:
The Definitive IT and Networking Event. Be There!
NetWorld+Interop Las Vegas 2003 -- Register today!
http://ads.sourceforge.net/cgi-bin/redirect.pl?keyn0001en
_______________________________________________
Acpi-devel mailing list
Acpi-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/acpi-devel
[prev in list] [next in list] [prev in thread] [next in thread]
Configure |
About |
News |
Add a list |
Sponsored by KoreLogic