[prev in list] [next in list] [prev in thread] [next in thread] 

List:       9fans
Subject:    [9fans] Re: Installing problems
From:       jmk () plan9 ! bell-labs ! com
Date:       1997-10-11 19:16:01
Message-ID: 199710111924.PAA08947 () cse ! psu ! edu
[Download RAW message or body]

[due to the secret agenda of the unix system support staff here i'm unable to
read news and reply to it on the same system, so i'm replying to this on the list.]

  I just press enter to get the default values as the installation manual 
  demands. Now there comes something about starting fs fileserver, but 
  directly after that weird crap starts flowing on screen. It looks something 
  like this 

   ##4";####;324#;3AA;##4";####;324#;3AA 

  This kind of code comes over and over until it fills the screen. 
  ...
  That EtherEZ  isn't in the supported hardware list but it should be same as
  Ultra. At least I think it is. 

i bet it isn't. these messages look like those the 8390 driver gives
when the packet ring in the on-board memory is corrupted. that usually means
that either the base address of the on-board memory or the size of that
memory is incorrect. i'm not familiar with the card you have, check the
values against what the kernel believes.

--jim

[prev in list] [next in list] [prev in thread] [next in thread]